Avoid Cutting Up Your Driveway

Written by jonah on January 10th, 2012. Posted in Home Page Posts, Uncategorized

For a double-swing gate, whether it is required for an extra-wide driveway or just a preferred aesthetic, an additional gate operator (motor and electronic control device) is required so that both sides of the driveway have a gate operator. This also means that electricity is required on both sides of the driveway. There is no getting around this because the gate operators require electricity to operate. However, communication is also required between the two operators, often termed “master” and “slave”. In order for them both to open and close at the same time, the timing needs to be established between them; thus, the need for communication.

Viking bluetooth modules

This master/slave communication is usually accomplished using a short multi-conductor cable between operators usually buried in a trench minimally 18″ underground. The cable length between operators can vary but greater distances require larger wire sizes which means more expense (e.g. up to 100 ft. requires 16 Gauge wire). Often times, customers would prefer not to have their driveway cut into and dug up to install the communication cable, particularly if they already have electrical power on both sides of the driveway.

The perfect solution is the Viking bluetooth accessory. This plug and play, wireless communication system has a range of up to 100 feet.The Viking Blue also offers a simple diagnostic system. These wireless diagnostics not only allow remote operation of timer adjustment, obstruction sensor and fine tune settings but also run pre-programed self diagnostics and technical data transmission to Viking support centers nationwide.
Imagine a gate operator that can speak to you and verbally indicate various parameters or operations. A gate operator that not only speaks to you but also listens and executes your verbal commands. Imagine installation with no more communication wires or trenching. Or that is no longer necessary to remove the operator’s cover when troubleshooting because it can be done at a convenient location in the vicinity. Imagine that troubleshooting remotely is possible by an authorized technician anywhere in the world.

Plug-in Adapter

VIKING VOICE RECOGNITION
Uses a state of the art algorithm, speaker independent , accent independent and noise canceling. Allows the use of voice commands for all functions available in the Viking Blue Module

VIKING SPEECH TECHNOLOGY
Intelligent speech technology allows the gate operator to communicate verbally with you, answering questions related to the state of the gate operator and commands.

VIKING INTERFACE
The Viking Blue Module uses a graphical interface to visually find voltages, amperages and other various setting and functions of the gate operator.

VIKING BLUE MASTER SLAVE
Forget about wires! The Viking Blue module establishes a reliable wireless communication between master and slave operators up to 100 feet in range.

VIKING BLUE TELESERVICING
The Viking Blue module is capable of diagnosing the gate operator and communicating the results to the Viking Tech Support Line, allowing rapid troubleshooting and resolution.

Trackback from your site.

Leave a comment